After starting the BadgeBuilder® Visitor installer, select the "Administration Station" set up type. You will then be asked to select the directory where the BadgeBuilder® Visitor program is to be located. If the directory does not exist it will be created.
Next you will need to specify where the BadgeBuilder® Visitor database is, or is going to be installed. If it already exists at that location you will be asked if you wish to over-write it with an initial database. If in doubt, select NO. The location can be anywhere on the network, and you can install the initial database for the BadgeBuilder® Visitor network, if you wish.
At the end of the installation you can select whether or not to install BadgeBuilder®. You may wish to do this to allow the administrator to design badges or make changes to the BadgeBuilder® database. However, it will be necessary to equip the administrator machine with a BadgeBuilder® Visitor Security Key (Dongle) in order for this to be possible.